With this unit,
envelope printing becomes a very profitable operation. Increasing your profits
is important, choose the envelope feeder that does it all....
versatile feeder in the Graphics Arts Industry -- Continuous load Continuous
Delivery -- does not require any special installation. It does not have to be
timed or synchronized to the press.
Feeder can be
moved from press to press and operating within minutes on a Hamada, AB
Dick, Davidson, ATF Chief, Toko, Multilith, Ryobi, Heidelberg Windmill and many
Will feed index
cards, IBM cards etc. All Stainless steel and aluminum construction.
any offset press
a large variety of envelope sizes
unusual and hard-to-feed stock
production time in half
set up on or off the press
in minutes and simple to operate
synchronization to press
up to 10,000 IPH
while press is running
side covers: 15" Feder Table: 11"
Feed Table 38" Minimum: Feed Table 26"
(Mounted on rollers)
up to 10,000 envelopes per hour
from 3" x 5" up to 9" x 12"
500 envelopes at a time
small offset presses
60HZ, 220V (optional)
conveyor at delivery end
Envelope Stream Feeder was designed as an automated helper for the
printer. Once the feeder is set up, it requires very little of the
printers time except for keeping it loaded. This gives the printer more
time for quality printing and stock control. The press can run
continuously at any speed the printer chooses.
printers have struggled to print envelopes and other hard to feed
materials. Now the problem is solved with the Thompson T-100 envelope
Stream Feeder. With the feeder there is no need to stop to reload, no more
shimming, and no more loading small amounts. Your press can run all day
and print three to six times as many envelopes. This means increased
profits for every hour you run. Set up time is fast and easy. The feeder
loads from the top and feeds from the bottom to keep a continuous stream
of envelopes to the press and is reloaded with the press running. This
eliminates wasted time from stop, load, and go envelope printing. It also
helps prevent doubles from sticky envelopes.
The T-100 is
a free standing unit mounted on casters. The base height is adjustable to
aid in leveling it to the press. It can be set up on or off the press in
less than three minutes. It is set on the elevator table of the press and
positioned between the press stock guides. A rubber tarp strap holds it
tight against the press. When the job is finished, disconnect the tarp
strap and roll it away.
will stack eight to twelve envelopes under the press sucker feet. The
stack of envelopes is controlled by a microswitch which keeps the stack a
constant height at all times. As the press picks up the envelopes the
microswitch puts more envelopes under the bottom of the stack. The feeder
motor only runs when the press needs more envelopes. No timing device is
needed. The T-100 can feed in excess of 10,000 envelopes per hour and the
speed of printing is controlled by the printer.
The T-100 is
fully adjustable to feed from 3"x5" to 10"x13".
Adjustment is fast and easy. Up to 500 envelopes can be loaded at a time
and more can be added at any time with the press running. There is no need
to stop the press until the job is finished. Big savings can also be made
on short runs of hard to feed envelopes or other hard to feed materials.
is shipped with the side covers, front and rear stock guides removed. It
can be fully assembled with only a Phillips head screwdriver.
International Envelope Feeder Prices
$$$ $AVE $$$
$200.00 Lower USA 48
5 O-Ring Set
Main Wide Belt
Above Belts are
for Sandco, Thomson and Phoenix Envelope Feeders